Dryer Vent Safety

Clothes dryers evaporate the water from wet clothing by blowing hot air past them while they tumble inside a spinning drum. Heat is provided by an electrical heating element or gas burner. Some heavy garment loads can contain more than a gallon of water which, during the drying process, will become airborne water vapor and leave the dryer and home through an exhaust duct (more commonly known as a dryer vent).
 
A vent that exhausts moist air to the home exterior has a number of requirements:Dryer Vent Safety - Northville Michigan Home Inspector - inspect_dryer_vent
  1. It should be connected. The connection is usually behind the dryer but may be beneath it. Look carefully to make sure it’s actually connected!
  2. It should not be restricted. Dryer vents are often made from flexible plastic or metal duct, which may be easily kinked or crushed where they exit the dryer and enter the wall or floor. This is often a problem since dryers tend to be tucked away into small areas with little room to work. Vent hardware is available which is designed to turn 90° in a limited space without restricting the flow of exhaust air. Restrictions should be noted in the inspector's report. Airflow restrictions are a potential fire hazard!
  3. One of the reasons that restrictions are a potential fire hazard is that, along with water vapor evaporated out of wet clothes, the exhaust stream carries lint – highly flammable particles of clothing made of cotton and polyester. Lint can accumulate in an exhaust duct, reducing the dryer’s ability to expel heated water vapor, which then accumulates as heat energy within the machine. As the dryer overheats, mechanical failures can trigger sparks, which can cause lint trapped in the dryer vent to burst into flames. This condition can cause the whole house to burst into flames! Fires generally originate within the dryer but spread by escaping through the ventilation duct, incinerating trapped lint, and following its path into the building wall.
InterNACHI believes that house fires caused by dryers are far more common than are generally believed, a fact that can be appreciated upon reviewing statistics from the National Fire Protection Agency. Fires caused by dryers in 2005 were responsible for approximately 13,775 house fires, 418 injuries, 15 deaths, and $196 million in property damage. Most of these incidents occur in residences and are the result of improper lint cleanup and maintenance. Fortunately, these fires are very easy to prevent.

The recommendations outlined below reflect International Residential Code (IRC) SECTION M1502 CLOTHES DRYER EXHAUST guidelines:

Duct construction.
Exhaust ducts shall be constructed of minimum 0.016-inch-thick (0.4 mm) rigid metal ducts, having smooth interior surfaces, with joints running in the direction of air flow. Exhaust ducts shall not be connected with sheet-metal screws or fastening means which extend into the duct.

This means that the flexible, ribbed vents used in the past should no longer be used. They should be noted as a potential fire hazard if observed during an inspection.
Duct length.
The maximum length of a clothes dryer exhaust duct shall not exceed 25 feet (7,620 mm) from the dryer location to the wall or roof termination. The maximum length of the duct shall be reduced 2.5 feet (762 mm) for each 45-degree (0.8 rad) bend, and 5 feet (1,524 mm) for each 90-degree (1.6 rad) bend. The maximum length of the exhaust duct does not include the transition duct.
This means that vents should also be as straight as possible and cannot be longer than 25 feet. Any 90-degree turns in the vent reduce this 25-foot number by 5 feet, since these turns restrict airflow.

A couple of exceptions exist:
  1. The IRC will defer to the manufacturer’s instruction, so if the manufacturer’s recommendation permits a longer exhaust vent, that’s acceptable. An inspector probably won’t have the manufacturer’s recommendations, and even if they do, confirming compliance with them exceeds the scope of a General Home Inspection.
  2. The IRC will allow large radius bends to be installed to reduce restrictions at turns, but confirming compliance requires performing engineering calculation in accordance with the ASHRAE Fundamentals Handbook, which definitely lies beyond the scope of a General Home Inspection!
Duct termination.Dryer Vent Safety - Northville Michigan Home Inspector - dryer_vent_safety
Exhaust ducts shall terminate on the outside of the building or shall be in accordance with the dryer manufacturer’s installation instructions. Exhaust ducts shall terminate not less than 3 feet (914 mm) in any direction from openings into buildings. Exhaust duct terminations shall be equipped with a backdraft damper. Screens shall not be installed at the duct termination.
Inspectors will see many dryer vents terminate in crawlspaces or attics where they deposit moisture, which can encourage the growth of mold, wood decay, or other material problems. Sometimes they will terminate just beneath attic ventilators. This is a defective installation. They must terminate at the exterior and away from a door or window! Also, screens may be present at the duct termination and can accumulate lint and should be noted as improper. 
Duct size.
The diameter of the exhaust duct shall be as required by the clothes dryer’s listing and the manufacturer’s installation instructions.
Look for the exhaust duct size on the data plate.
Transition ducts.
Transition ducts shall not be concealed within construction. Flexible transition ducts used to connect the dryer to the exhaust duct system shall be limited to single lengths not to exceed 8 feet (2438 mm), and shall be listed and labeled in accordance with UL 2158A.
In general, an inspector will not know specific manufacturer’s recommendations or local applicable codes and will not be able to confirm the dryer vent's compliance to them, but will be able to point out issues that may need to be corrected.
 by Nick Gromicko, Rob London and Kenton Shepard
Humidifier Maintenance
Tips for maintaining your whole house humidifier.
Read More...
Silicon Caulk Application
How to replace silicone caulk.
Read More...
Water Heater Maintenance
Water Heater Maintenance
Read More...
How To Prevent Termites
Although termites are more common in older homes, termite control can even be a problem in brand new homes. When builders clear trees from a site to build new homes, the termites can migrate to the wood stored on the site. A concrete slab or brick construction is no guarantee that termites will not eventually invade a home because termites can work their way up through the ground into minuscule cracks in the concrete
Read More...
Common Defects
With common issues it's typically a matter of a relatively simple fix to correct the issue, however left alone some of these issues could result in easily avoidable larger issues down the road. While conducting my home inspection I feel it's my job...
Read More...
Downspout Extensions
This should have been added to my Common Issues Blog being one of the most common installations. While installing downspouts so they terminate above the roof surface isn't a "defect" I always recommend routing downspouts to the gutter...
Read More...
Electrical Safety
Electricity is an essential part of our lives. However, it has the potential to cause great harm. Electrical systems will function almost indefinitely, if properly installed and not overloaded or physically abused. Electrical fires in our homes claim the lives of 485 Americans each year and injure 2,305 more. Some of these fires are caused by electrical system failures and appliance defects, but many more are caused by the misuse and poor maintenance of electrical appliances, incorrectly installed wiring, and overloaded circuits and extension cords. Some safety tips to remember:
Read More...
Environmental Concerns (Asbestos)
The Ancient Greeks named the mineral asbestos, meaning inextinguishable. Apparently even the Greeks were aware of the harmful properties in asbestos and the effects of breathing asbestos dust. The Greek geographer Strabo and the Roman naturalist Pliny the Elder mentioned a sickness common with workers who created cloths using asbestos fibers.
Read More...
Galvanized Steel Plumbing
Where water pressure is poor in the distribution system, the most common cause is corroded galvanized steel. Galvanized plumbing can close down so that the inner diameter is reduced to 1/8” or less. The only solution is to replace the plumbing lines, typically with copper.
Read More...
High Efficiency Lights
Environmentally friendly lights/Mercury Vapor.
Read More...
Ice Damming - Roof Leaks
A typical ice-damming event occurs when the heat escapes from the living quarters into the attic and eventually warms the roof deck. The combination of the sun and the interior heat combine to accelerate and exacerbate this process.
Read More...
Inspect Before Listing
Having a pre-list inspection will give the seller the opportunity to repair or upgrade those items that will no doubt be pointed out during the purchase inspection. Being able to limit the number of items needing attention will increase the marketability of the property being sold.
Read More...
Radon
Radon, because it is a gas, is able to move though spaces in the soil or fill material around a home's foundation. Michigan homes tend to operate under a negative pressure - this is especially true in the lowest portions of the home and during the heating season.
Read More...
Sump Pump Operation
Sump pumps are self-activating electrical pumps that protect homes from moisture intrusion and are very common in Southeastern Michigan homes. They are usually installed below basement or crawlspace floors to remove rising groundwater and surface runoff before it has a chance to seep into the home.
Read More...
TPR Vales and Discharge Piping
TPR (temperature pressure relief) valves are safety devices installed on water heating appliances such as boilers and domestic water supply heaters. TPRs are designed to automatically release water in the event that pressure or temperature in the water tank exceeds safe levels.
Read More...
Aging in Place
"Aging in place" is the phenomenon describing senior citizens' ability to live independently in their homes for as long as possible. Those who age in place will not have to move from their present residence in order to secure necessary support services in response to their changing needs.
Read More...
Ash Tree Enemy
Damage to Ash trees throughout the United States.
Read More...
Bats in the attic
Bat guano can build up in attics and eaves that have been used by bats, and even if the human occupants of the building are not aware of the dung, they may be harmed by it.
Read More...
* Indicates required questions
Name *
First Last
Email *
Phone # *
Property Address (Include City) *
How can we help you?
VerificationCode
Enter code in image: